Revel RB-1032 Manual página 40

Battery level
To check the battery level press the button at the back of the battery:
• When the battery is fully charged, all three LEDs are on.
• When the battery is half empty, two LEDs are on.
• When the battery is empty, only one LED is on. Charge the battery immediately.
Charging
• Place the AC charger on a flat and stable surface within about 1 meter from the power
supply socket.
• Remove the battery from the power tool. Press and hold the battery release button (4)
and slide out the battery at the same time.
• Slide the battery to the AC charger maximally so that it locks in place.
• Connect the AC charger to the power supply socket.
• When the battery is fully charged, slide it out from the AC charger and slide it in the
power tool so that it locks in place.
Charging indicators
The AC charger has charging indication lights which indicate the status of the charging process:
LED
Red
Green
• AC charger and battery may heat up during charging. It is a normal behavior.
• When power tool is not in use, it is recommended to charge the battery every three
months.
• When you notice that the power tool performance is decreasing, recharge the battery.
Mounting and replacing blades
Notes:
• Before mounting and replacing a blade, take out the battery.
• Use protective gloves during assembling.
1. Place the saw on its side, on a flat and stable surface.
2. Press and hold the blade lock button.
3. Unscrew the screw securing the blade with included hex key.
4. Take out the washer.
5. Slide the blade cover and take out the blade. Mount a new blade.
6. Put the washer in and screw in the screw.
EN
Battery charging in progress
Battery charging finished, battery fully charged
40
Status