Publicidad
Idiomas disponibles
Idiomas disponibles
occurring to other people or their property
•
Before using, always visually inspect to see that the tines, bolts are not worn or
damaged. Replace worn or damaged tines and bolts in sets to preserve balance
•
While operating the machine. Always wear substantial footwear and long
trousers. Do not operate the machine when barefoot or wearing open sandals
Handling
•
Operate the tool in daylight or good artificial lighting only.
•
The appliance must be assembled correctly before use.
•
Replace worn or damaged parts for safety. Use only original spare parts. Parts
not produced by manufacturer may cause poor fit and possible injury.
•
If possible avoid using the tool with wet grass or applying particular care to
avoid slipping.
•
Make sure to have a safe stand when working on inclines.
•
Move the tool at walking speed only.
•
Always work in a perpendicular position/direction to the slope. Never work in
upward or downward direction.
•
Take particular care when changing the work direction on the slope.
•
Do not work on extremely steep slopes.
•
Take particular care when turning the tool around or pulling it towards yourself.
•
Stop the work tools if the tool must be tilted for transport purposes. Stop the
work tools if areas other than grass patches must be crossed and whenever the
tool is moved to and from the area to be worked.
•
Do not use the tool with damaged or no safety devices installed, e.g., without
baffle plated and/or collection devices.
•
Do not change the motor setting and do not overwork the motor.
•
Disengage all work tools and drives prior to starting the motor.
•
Start the tool with due care in accordance with the manufacturer's instructions.
Make sure to keep a safe distance between your feet and the work tools.
•
The tool must never be tilted when starting the motor unless the tool must be
lifted off the ground to be started. If this should be the case only tilt the tool as
far as necessary and only lift the side pointing away from the operator off the
ground.
•
Never lift or carry a tool with the motor running.
•
Switch off the motor and pull the mains plug in the following cases:
1) before inspecting or cleaning the tool or before performing any works on it.
2) If an object got caught or hit. Check the tool for damages and perform the
required repairs before your restart and continue working with the tool.
3) If the tool starts to vibrate abnormally (inspect immediately)
•
Switch off the motor and pull the mains plug whenever you leave the tools
alone.
General Safety
•
Use a power cable H05 RN-F or H05 VVF or greater, with minimum cross
section of 2x1.5mm2 and max length of 20m.
•
Use a face mask if dusty.
•
Keep clear of discharge openings at all times.
•
Do not use solvents or cleaning liquids to clean your machine – use a blunt
EN - 11
Publicidad
