Efapel 40215 Manual De Instrucciones página 22

CONNECT THE ELECTRONIC DIMMER TO THE NETWORK -
1 STEP
ST
Press RESET 7 seconds
until all the LEDs are
at half brightness.
2 STEP
ND
Click on PROG.
3 STEP
RD
Click on the com-
mand button of the
Installation Key (Ref.
40925) in
proximity to
Electronic Dimmer.
22
close
the
ONLINE
1.1 - The LED ON
switches on.
2.1 - The LED ON
starts to blink, indicat-
ing that it is ready to
be added to the net-
work, during a period
of 10 seconds .
3.1 - The LED starts to
blink red, indicating
that it is searching for
the device that is going
to be added.
3.2 - The LED blinks
green and switches off,
the device's LED ON
switches off and the A,
B, D, C LEDs switch on
and off in sequence,
indicating that
Electronic Dimmer was
successfully added to
the network.
Note: If the Installation Key LED
does not turn green and switch
off, repeat from the 1 step.
st
the