Publicidad
Idiomas disponibles
Idiomas disponibles
Methods of installation
Note: Please ensure to use the accessories provided along with the product to
install this electric water heater. This electric water heater can not be hung
on the support until it has been confirmed to be firm and reliable.
Otherwise, the electric water heater may drop off from the wall,
resulting in damage of the heater, even serious accidents. When
determining the locations of the bolt holes, it shall be ensured that
there is a clearance not less than 0.2m on the right side of the electric
heater . This may be required during maintenance of
Installation
This electric water heater shall be installed on a solid wall. lf the
strength of the wall cannot bear the load equal to two times of the total
weight of the heater filled fully with water, it is then necessary to install
a special support.
After selecting a proper location, determine the positions of the two
holes used far expansion bolts with hook. Make two holes in the wall
with the corresponding depth and size matching the expansion bolts
attached with the heater insert the screws, turn the hook
upwards,tighten the nuts to fix firmly,and then hang the electric water
heater on it (see Fig.2).
lnstall the supply socket on the wall. The supply socket should be 3
pins, single phase, 230V/16A. lt is recommended to place the socket
on the right side above the heater. The height of the socket to the
ground shall not be less than 1.8m
lf the bathroom is too small, the heater can be installed at another
place. However, in arder to reduce the pipeline heat losses, the
installation position of the heater shall be as near as possible to the
heater.
Expansion bolt
(with hook)
Fig.2
4
heater.
Publicidad
