Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Cutting Height Adjustment
WARNING
!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components
are HOT. Avoid serious burns, allow sufficient time for all
components to cool.
Pull the cutting height adjust lever (A, Figure 9)
outward, and move to the desired cutting height. The
highest cutting position is Notch 9, and the lowest
cutting position is Notch 1 (Figure 10). The lever will
set all wheels to the same cutting height.
A
Figure 9: Adjusting cutting height
Mulching Operation
For best mulching results, cut up to a maximum of 1/3 of
grass length and recycle ONLY when grass is dry.
1. Make sure the discharge deflector and grass bag are
removed, and the mulching plug is installed.
2. Set the cutting height adjust lever in the highest cutting
position (Notch 9).
3. Proceed mowing slowly. Gradually lower the cutting
height to obtain the best combination of cutting and
mulching performance. Cutting too much grass in one
pass, or cutting wet heavy grass may cause clumping or
plugging of the mower deck.
12
!
1.25 in
Figure 10: Cutting height settings (approximate)
Installing the Discharge Deflector
!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components
are HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Raise the mulching cover (A, Figure 11).
2. Install the deflector (B) to the deck under the mulching
cover, making sure that the locking tabs on the deck (C)
go through the slots in the deflector (B).
3. Lower the mulching cover against the deflector.
B
Figure 11: Installing the discharge deflector
WARNING
C
www.snapper.com
4.00 in
!
A
Publicidad
