Hansgrohe Metris 31101 Serie Instrucciones De Montaje página 3

Installation notes
• Flush the hot and cold supplies thoroughly
before installing the faucet. Damage to the
faucet caused by debris is not covered under the
warranty.
• The hot and cold supplies should be of equal
pressure.
• The faucet should not be used with a continuous
flow water heater.
• Do not install the faucet on a sink with a raised
edge.
• Strong light sources should not shine directly on
the sensor window of the faucet.
• The faucet should only be used with the battery
pack or power pack supplied by Hansgrohe.
Do not attempt to use any other battery pack or
power pack.
• The faucet incorporates automatic range adjust-
ment -- the sensor automatically adjusts itself to
local conditions (lavatory, brightness, etc.)
• The distance between the switch on/off point
to the faucet is approx. 6¼" - 8" under normal
conditions. The detection area may be less for
dark, non-reflective objects, or greater for bright,
highly reflective objects.
• If the sink is very small or highly reflec-
tive, follow the range reduction instruc-
tions on page 14. When the faucet is in re-
duced range mode, the LED in the sensor window
will flash while the faucet is not in use.
• Drops of water or condensation on the sensor
window may cause the faucet to run.
• If the LED in the sensor window flashes while the
faucet is in use, the battery is low, but the faucet
may still be used. If the LED stays on, the faucet
will not run, and the battery must be changed.
• If the power to the outlet or to the building fails,
the 110 V version of the faucet will not run.
• The spray pattern will be unattractive
immediately after installation or service,
due to air in the faucet. After the faucet
is used 10 - 15 times, the spray pattern
will clear.
3