Publicidad
Idiomas disponibles
Idiomas disponibles
When installing the hood, the minimum safety distances mentioned
above must be kept in mind.
To install the hood, please read the following installation notes
carefully:
• Attach the discharge conduit to the air outlet adapter and use
ST3x6 screws (2) to hold both parts.
• Secure the decorative chimney bottom to the hood by using
(2) M2.9 x 14 mm mounting screws and (2) 7 x 27 mm
drywall anchors (Fig.2).
• Level and secure the hood by using (2) ST5 x 45 mm
mounting screws and (2) 10 x 45 mm drywall anchors to the
wall, then hang the hood up (Fig.3).
• Please note that the distance between these 2 screws should
be 230mm, and the distance between the screws and the
bottom of hood should be 130mm(Fig.2).
• Take out the aluminum cassette fillter, then level the hood
and secure it to the wall further with (2) ST4.2 x 30 mm
mounting screws and (2) 10 x 45 mm drywall anchors( Fig.4).
• If no charcoal fillter need to be installed, install the aluminum
cassette fillters back, and connect the hood to the mains,
then it can start to work( Fig.5).
21
Publicidad
