Descargar Imprimir esta página

Westinghouse WGen12000DFc Manual Del Usuario página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTROL PANEL COMPONENTS
1
10
automatically start the engine. Push again to stop
the engine.
Indicates that power is ON. Light
will remain illuminated while the unit is ON.
Turns battery ON and OFF. Must be
ON before electric or remote start.
Low Idle minimizes fuel consumption,
noise, and engine wear by lowering the engine RPM
during intermittent use. See LOW IDLE section for
important use considerations.
operation.
Two-port 5V/2.1A USB outlet. Accepts
Type A USB plugs.
Displays voltage, frequency, total
hour meter, and run/maintenance timer.
controls total output of all outlets to protect the
generator from overload or short circuit.
ST Switch (sold separately) to the control panel.
with the included battery charger.
externally ground the generator.
2
3
5
4
12
14
Push once to
Used to select gas or propane
: The main circuit breaker
Connects the Westinghouse
: Used to charge the battery
The ground terminal is used to
COMPONENTS
6
7 7
13
16
15
or 240V up to 50 amps.
the current that can be delivered through the NEMA
L14-30R receptacle to 30 amps.
240V up to 30 amps.
the current that can be delivered through the NEMA
L5-30R receptacle to 30 amps.
Receptacle can supply a maximum of 30 Amps.
limits the current that can be delivered through
each NEMA 5-20R receptacle to 20 Amps.
carrying a maximum of 20 amps on a single
receptacle or a combination of both receptacles.
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
Westinghouse Outdoor Power Equipment | 11
8
19
18
17
11
Receptacle can supply either 120V
Circuit breaker limits
Receptacle can supply either 120V or
Circuit breaker limits
Circuit breakers
Each receptacle is capable of
The CO Sensor
9

Publicidad

loading