Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL
naab
3
2
CONNECTIONS AND OPERATING ELEMENTS
1. STEREO
Unbalanced stereo line input with 3.5 mm mini jack socket. Use a shielded stereo audio cable to connect, for
example, a notebook to the Media DI box.
2. TRS LEFT / RIGHT
Line inputs with 6.3 mm jack sockets suitable for both unbalanced and balanced cabling. Use shielded audio
cables, for example, to connect a submixer to the Media DI box.
3. RCA LEFT / RIGHT
Line inputs with cinch sockets. Use shielded audio cables, for example, to connect a CD player to the Media DI box.
4. OUTPUT LEFT / RIGHT
Balanced stereo line output with two male 3-pin XLR sockets. Use shielded audio cables to connect the Media DI
box to a balanced stereo input of a mixing console or audio interface.
5. STEREO / MONO
MONO: Move the switch to the depressed MONO position to sum an incoming stereo signal to mono and output it
at both XLR output jacks simultaneously. With the help of this function, the Media DI box can also be used as a split
box with two galvanically separated outputs.
STEREO: When STEREO is not pressed, the LEFT input signal is output at the LEFT output and the RIGHT input signal is
output at the RIGHT output.
6. LIFT / GND
Switch for disconnecting the ground connection from the input and output (ground lift). In the non-pressed
position, the ground connection is disconnected; the connection is established when the switch is pressed.
The ability to prevent a humming loop using the ground lift switch depends on the grounding of the connected
device. It is therefore possible that the switch is able to effectively reduce or eliminate humming when it is either
up or down, depending on circumstances.
EN
3
1
2
2-Channel Media DI Box
passive
6
7
4
4
5
12
Publicidad
