Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Preparation Before Use
1. Remove the protective film
Remove the protective films on the robot.
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
8
3. Place the charging dock on the level ground
against the wall and connect it to a power outlet
＞ 0.5 m
＞ 1.5 m
＞ 0.5 m
Note:
• Keep the immediate area 1.5m in front of the charger and 0.5m to both
sides of the charging dock clear of objects.
• To ensure you can connect to the robot with your phone well, make sure
the robot and charging dock are within the range of Wi-Fi.
• Do not place the charging dock in an area with direct sunlight or where
other objects might block the signal, as this may hinder the robot from
returning to the charging dock.
4. Place the robot onto the charging dock to
recharge. The robot will turn on automatically and
begin recharging
Battery Level Indicator
• White: Battery level
is more than 15%
• Orange: Battery
level is less than 15%
Note:
• Fully charge your robot before first-time use.
• Don't install the mopping module while charging. Be extra careful with
wet mop as it can damage the floor.
Tidy up Any
Loose Cord
Publicidad
