Publicidad
Idiomas disponibles
Idiomas disponibles
carbide tool is nicked, or if the cutting edge cannot be restored by honing,
have an experienced mechanic regrind the tool.
8.
Wrap each carbide bit separately for storage when not in use, or store them
in hole pockets drilled in wood.
opposite that shown in Fig. 2). "Climb-
Cutting" increases the chance for loss of
control resulting in possible injury. When
"Climb-Cutting" is required (backing
around a corner), exercise extreme caution
to maintain control of router. Make smaller
cuts and remove minimal material with
each pass.
For assistance with your tool, visit our website at www.porter-cable.com for a
list of service centers or call the Porter-Cable help line at 1-800-487-8665.
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts
should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic
parts. They could possibly dissolve or otherwise damage the material.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are
making good contact in the outlet. Also, check for blown fuses or open circuit
breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for
the life of the unit under normal operating conditions. No further lubrication is
necessary.
BRUSH INSPECTION
For your continued safety and electrical protection, brush inspection and
replacement on this tool should ONLY be performed by an AUTHORIZED
PORTER-CABLE SERVICE STATION or a PORTER-CABLE
FACTORY SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest
authorized Porter-Cable Service Station to be thoroughly cleaned and inspected.
Have worn parts replaced and lubricated with fresh lubricant. Have new brushes
installed, and test the tool for performance.
Any loss of power before the above maintenance check may indicate the need
for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION. If proper operating voltage is present, return your tool
to the service station for immediate service.
Avoid "Climb-Cutting"
(cutting in direction
TROUBLESHOOTING
MAINTENANCE
Wear ANSI Z87.1 safety glasses while using compressed
air.
(If applicable)
Fig. 2
11
•
DELTA
Publicidad
