Halo PRIME 300 Guía Esencial página 24

TEMPERATURE PROBE
WHAT IS RTD TEMPERATURE PROBE?
The Prime 300 has an RTD (Resistance Temperature Detector) sensor probe inside the grill.
The probe is usually located on the left-hand side of the cooking chamber, where the hopper is
shielded with "C" bracket.
RTD-TEMPERATURE PROBE
Located inside the smoke chamber, on the left, is
the RTD-temperature probe. It is a small, vertical
piece of stainless steel. The temperature probe
measures the internal temperature of the unit.
When the temperature is adjusted on the Control
Board, the temperature probe will read the actual
temperature inside the unit and adjust to the
desired temperature.
IMPORTANT
The temperature of your unit is highly affected on ambient outdoor
weather, quality of pellets used, flavor of pellets, and the quantity of food
being cooked.
24
24
MEAT PROBE
The meat probe measures
the internal temperature
of your meat in the smoke
chamber. Plug-in the meat probe adapter to the meat
probe connection port and insert the stainless-steel
meat probe into the thickest portion of your meat and
the temperature will be displayed on the control board.
To ensure the meat probe is connected properly to the
connection port, feel and hear it snap into place.
IMPORTANT
• When placing the meat probe into
your meat, ensure the meat probe
and meat probe wires avoid direct
contact with flame or excess heat.
This can result in damage to your
meat probe. Run the excess wire out
along the edge the front lid. When
not in use, disconnect from the meat
probe connection port and place
aside to keep it clean and protected.
• Make sure to place the protective
cap in place to prevent any moisture
accumulation inside the jack
receptacle.
Wired meat
probe jack
protective cap