Knirps 85897KN40GG Instrucciones De Montaje Y Uso página 8

GB
Congratulations –
with your new granite base from Knirps,
you have purchased a product of the
highest quality. And you will see: The
longer you enjoy its benefits, the more
fun you will have with it. With more than
200 million articles produced, Knirps is
one of the leading manufacturers around
the world. Sophisticated technology and
careful material selection are a matter of
course for us.
And all that remains now is to hope that
you savour many sunny days with your
new OASIS product – or quite simply: re-
laxation at its finest!
Knirps Granite Base –
Assembly instructions and
user manual
Carefully read through the
complete assembly instruc-
tions and user manual, parti-
cularly the safety instructions. Failure to
heed this instruction may result in seve-
re injury or damage to the granite base.
Hold onto the assembly instructions and
user manual for future reference or in or-
der to pass it on to third parties.
Your safety
Please observe the following
safety instructions. The manu-
facturer is not liable for dama-
ge as the result of failure to
comply.
The granite base is not a children's toy.
Children could crush their fingers or feet.
The granite base is very heavy. It must
always be transported by 2 persons.
The granite base should be erected by a
competent adult.
Never leave the granite base unattended
when it is in an upright position – if it falls
over, it could result in severe injury.
Keep in mind that, depending on wind in-
tensity and diameter of the sun shade,
this granite base may also be too "light".
8
Make sure that the sun shade is closed
in the event of incoming wind.
Proper use
Depending on the model, the granite ba-
se is suitable as a stand for sun shades
with a pole diameter of no more than
60 mm.
The granite base is intended for dome-
stic use only. It is not suitable for com-
mercial use.
Before you use the granite base, please
first carefully read through the safety ins-
tructions. Only in this way, will you be ab-
le to use the granite base in a safe and
reliable manner.
It is imperative that you observe the nati-
onal regulations in force in your country
which also apply in addition to the regu-
lations in this assembly instructions and
user manual.
Mounting the stand tube
You will need:
– the enclosed socket wrench
– The help of 1 person
1. Lift the granite base and place it up-
right on one of its lateral surfaces.
Have a second person hold the
granite base!
2. Put the small rubber disc 1, the shim 2
and the snap ring 3 over the screw 4.
3. Run the screw through the granite
base from the bottom (see Figure A).
4. Push the large rubber disc 5 on the
top of the granite base over the th-
read of the screw 4 (see Figure A).
5. Screw the threaded hole of the stand
tube 8 onto the screw 4 and tighten it.
6. Carefully tilt the granite base back to
the ground.
Using the inserts
Use the inserts 7 that correspond to the
size of your sun shade's pole.