AOSmith AOS-HERO-CHR Manual Del Propietário página 5

STEP 1 Site Setup
Note: This system requires an existing faucet hole 1" to 1 1/2" in diameter in the sink
or countertop to install the supplied dedicated faucet. You may also replace an existing
kitchen sink sprayer, soap dispenser, or pre-existing hole on the sink or countertop.
If drilling a new hole, ensure faucet body will mount flat against surface and there is
sufficient tubing between faucet body and system manifold. If drilling, we strongly
recommend using a professional. Please wear safety glasses when drilling.
1. Unpack and unwrap box contents.
2. Turn off COLD water supply. Turn on the kitchen faucet to release pressure and
allow water to drain from the line.
3. Temporarily place system manifold and water tank into the under sink cabinet or
desired location to ensure adequate space and proper positioning.
4. Measure blue and red tubing from faucet hole to system manifold, then measure
yellow tubing from the top of the water tank to the system manifold. Ensure all
tubing lengths are sufficient for making connections. Do not cut tubing before
following next instructions.
5. Remove system manifold and water tank from under your sink to begin installation.
13.74"
(34.9 cm)
13.74
(34.9 cm
9.06"
(23 cm)
DRAWING NOT TO SCALE, SYSTEM AND TANK ENLARGED.
NEED HELP? GIVE US A CALL 877.333.7108
INSTALLATION GUIDE
"
)
4.5"
(11.5 cm)
2
12.93"
(33 cm)