AOSmith AOS-HERO-CHR Manual Del Propietário página 6

INSTALLATION GUIDE
3
STEP 2 Install Air Gap Faucet
1. Feed pre-connected air gap faucet through
countertop hole.
2. Underneath countertop, slide the slotted faucet
washer onto threaded base of faucet. Washer
should be in between countertop and white
plastic spacer. If needed, loosen nut to
move spacer down to create enough
room for the washer.
3. Tighten nut with adjustable wrench. Do
not over tighten.
STEP 3 Install Drain Saddle
WARNING: Ensure all electrical appliances and outlets are turned off at circuit breaker
before continuing. Please wear safety glasses when drilling.
1. Identify drain outlet location on
drainpipe to install drain clamp. Do not
install drain clamp on the same drainpipe
as garbage disposal. Mount drain clamp
as low as possible on the vertical or
horizontal drainpipe tailpiece.
2. Using the drain connector hole as a
template, drill a 7/16" hole into the
drainpipe. Only drill through one side of
the drainpipe.
3. Take the connection half of the drain
clamp and attach the foam gasket. Do
so by removing the center hole and
protective cover from the back of the
foam gasket. Align the foam gasket hole
with the hole on the inside of the drain
clamp. The adhesive side of the foam
gasket should be facing the inside of the
drain clamp. Press firmly to attach.
4. Insert nuts into the other half of the drain
clamp. Place both halves together around
the drainpipe, aligning with the hole you
drilled. Use drill bit to help align.
5. Tighten nuts and screws to secure the
drain clamp halves around the drainpipe.
Tighten with screwdriver. Do not over
tighten.
NEED HELP? GIVE US A CALL 877.333.7108
1
2
3
RED BLUE