Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not move or repair any unit by yourself. Must be done by
qualifi ed installer or qualifi ed service person. There is high
voltage inside the unit. You may get electric shock when
removing the cover and main unit.
To transport the air conditioner, wear shoes with additional
•
protective toe caps.
•
To transport the air conditioner, do not take hold of the bands
around the packing carton. You may injure yourself if the bands
should break.
•
This appliance is intended to be used by expert or trained users
in shops, in light industry, or for commercial use by lay persons.
Selection of installation location
When the air conditioner is installed in a small room, provide
•
appropriate measures to ensure that the concentration of
refrigerant leakage occur in the room does not exceed the critical
level.
•
Do not install in a location where fl ammable gas leaks are
possible. If the gas leak and accumulate around the unit, it may
ignite and cause a fi re.
•
Install the indoor unit at least 8'2" (2.5 m) above the fl oor level
since otherwise the users may injure themselves or receive
electric shocks if they poke their fi ngers or other objects into the
indoor unit while the air conditioner is running.
•
Do not place any combustion appliance in a place where it is
directly exposed to the wind of air conditioner, otherwise it may
cause imperfect combustion.
7-EN
Installation
•
Suction duct length must be longer than 33.5" (850 mm).
•
When the indoor unit is to be suspended, the designated hanging
bolts W3/8" (M10) and nuts W3/8" (M10) must be used.
Install the air conditioner securely in a location where the base
•
can sustain the weight adequately. If the strength is not enough,
the unit may fall down resulting in injury.
•
Follow the instructions in the Installation Manual to install the air
conditioner. Failure to follow these instructions may cause the
product to fall down or topple over or give rise to noise, vibration,
water leakage or other trouble.
•
If refrigerant gas has leaked during the installation work, ventilate
the room immediately. If the leaked refrigerant gas comes in
contact with fi re, noxious gas may generate.
•
Use forklift to carry in the air conditioner units and use winch or
hoist at installation of them.
•
Helmet must be worn to protect your head from falling objects.
Especially, when you work under an inspection opening, helmet
must be worn to protect your head from falling objects from the
opening.
Refrigerant piping
•
Install the refrigerant pipe securely during the installation
work before operating the air conditioner. If the compressor
is operated with the valve open and without refrigerant pipe,
the compressor sucks air and the refrigeration cycles is over
pressurized, which may cause an injury.
•
Tighten the fl are nut with a torque wrench in the specifi ed
manner. Excessive tighten of the fl are nut may cause a crack in
the fl are nut after a long period, which may result in refrigerant
leakage.
– 4 –
EN
FR
ES
8-EN
Publicidad
