Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect the Wiring Looms
Remove the case cover and inserts.
Disconnect the three wiring looms from the circuit board by gently pressing
the connector tabs. Gently remove the grommets from the box.
Remove the Old Internal Clamp
Using the torx driver, remove the four internal clamp screws.
Lift out the valve unit from the case.
Remove and discard the internal clamp and the O-ring.
1062958-9-A
Case
Inserts
O-Ring
Internal Clamp
Wiring
Loom
2
Connector
Tab
Circuit
Board
Grommet
Solenoid Wiring
Loom
Solenoid
Internal
Clamp
Screw
Cap
Kohler Co.
Publicidad
