Sensor Installation Options; User Navigation - Hach LDO Manual Del Usuario

• Connect the sensor while power to the controller is off. The controller will look for and install new
sensors when it is turned on.
• Connect the sensor while power to the controller is on. Use the Scan Devices command to install
the new sensor:
Option Description
sc200 controller Go to MENU>TEST/MAINT>SCAN DEVICE
sc100 controller Go to MENU>TEST/MAINT>SCAN SENSORS
sc1000 controller Go to MENU>SYSTEM SETUP>DEVICE MANAGEMENT>SCANNING FOR NEW
DEVICES
Refer to Connect the sensor in a non-hazardous location

Sensor installation options

The installation and accessory options available for the LDO sensor are supplied with installation
instructions in the hardware kit.
hardware, refer to Replacement parts and accessories
Figure 5 Installation options
1 Rail mount
2 Float mount
3 Air blast system mount (not seawater probe
compatible)
Operation

User navigation

Refer to the controller documentation for keypad description and navigation information.
Figure 5 shows several installation options. To order installation
4 Chain mount
5 Union mount (not seawater probe compatible)
on page 8 for digital sensor connection.
on page 17.
English 9