Ruby S 10-20 N Manual De Instrucciones página 26

INSTRUCTIONS MANUAL
RUBY S 10-20 N
2 · 24H TIMER FUNCTION
1.Open the appliance as working conditions, (fan, warm, hot are all ok). This function through by Remote
control button.
2. Press button ,set the timer up to 24 hours, keep press button to increase the hours from
00:00--24:00 (01:00=1hour, ...24:=24:00 hours ect.) and the light is on.
PS: set as "00" means no set timer ,the light is off.
3 · THERMOSTAT INSTRUCTIONS
1. Open the appliance as working conditions, (fan, warm, hot are all ok). This function only through by
Remote control.
2. To adjust temperature, press the to set the desired temperature and the temperature set from
10 °C to 49 °C.
3. When the air temperature drops 2 degree below the set temperature, the heater will start heating with
(2000W).
4. When the air temperature high 1 degree or ≤ the set temperature, the heater will blow the cold air.
4 · WEEKLY TIMER FUNCTION
1. Open the appliance as working conditions, (fan, warm, hot are all ok). This function only through by
Remote control.
2. Before turn on the heater,set the time as real time.
WEEK Press "Set" button ,"1" light twinkle, press two buttons set the week from 1--7
(1=Monday...7=Sunday ect.)
HOUR Press "Set" button again,LED display front "00" twinkle, press two buttons set the Hours
from 01--00 (01=1 o'clock, 02=2 o'clock...00=24 o'clock ect.)
MINUTE Press "Set" button once more,LED display behind "00" twinkle, press two buttons set
the minutes from 00--59 (01=1 Minute, 02=2 Minute ect.)
PS: Press "Set" button, screen shows number will twinkle 5 seconds, you should operate in time,
otherwise appliance will get back to standby.
(Appliance will keep the right time until power off)
26