cecotec CONGA POPSTAR 14800 AQUA Manual De Instrucciones página 40

ENGLISH
Because the nozzle is set on the front rolling brush, the self-cleansing function can only clean
the front rolling brush.
To clean the rear rolling brush, switch the front and back brushes.
Fig. 11.
Note:
After the machine is used, the rolling brush will be soaked and must be placed in a ventilated
place to dry, so as not to affect the cleaning effect of the next use.
When the rolling brush is soaked, the machine cannot be used in an environment below 0 ºC to
avoid it from freezing and getting damaged.
Storage
After using this product, place it on the machine holder to prevent the wet rolling bristles from
contacting the floor for a long time, causing damage to it.
It is recommended to clean the Rolling brush before storage, and then store it in a cool place to
avoid mouldy bristles and odours that affect the product's lifespan.
The product handle can be pulled out after removing the two screws installed in the installation
instructions on "Handle assembly and body assembly installation", and then put back into the
packing box after opening the terminal block.
If the product is not going to be used for a long time, it is recommended to pack the machine
according to the above steps, store it in a cool and dry place. Do not place it in direct sunlight
or in a humid environment.
6. TROUBLESHOOTING
Problem
Rolling brush does not rotate
The roller brush is pressed by a heavy object or
involves too much hair
No water from the pump
It is blocked by foreign body
40
CONGA POPSTAR 14800 AQUA
Possible causes
No battery
Remove heavy objects
and clean up hair
The water in the clean
water tank has been used
up
Clean the dirt on the
nozzle and clean the
sewage tank
Solution
Charge the device
Refill the clean water
tank