Erbauer ETBV18-Li Manual De Instrucciones página 22

Controls
WARNING! Do not connect the battery pack to the product before it is
completely assembled!
01
Cartridge filter
1. Always assemble the cartridge filter (11a) for dry/wet vacuuming and blowing
operation.
2. Inspect the cartridge filter regularly. Do not use if you detect any damage.
3. Empty the dust tank (5) once full. We recommend to empty it when the product
does not reach a sufficient suction power.
4. Inspect and clean the cartridge filter regularly: tap the cartridge filter on a solid
surface to remove dust. Wash it with clear water and lit it dry thoroughly before
refitting it. Replace it with a new one when required.
NOTE: Do not squeeze or attempt to wring the filter. Allow to air dry.
02
On/off switch (Fig. L)
1. Switch the product on by setting the on/off switch (17) to its I position.
2. Switch the product off by setting the on/off switch to its O position.
03
Holders (Fig. M)
1. Store hose (13) and nozzles (9/10) as show in fig. M.
04
Safety valve
The product is designed with a safety valve to prevent water from entering the motor
unit (11) during wet vacuuming.
When the safety valve (floating ball assembly) has been activated by a rise in tank
water level, you will hear the motor change to a high pitch and the vacuum suction will
stop. In this event, switch the appliance off and remove battery.
22
MNL_ERBAUER_18 V vacuum cleaner_ETBV18-Li_IMGB_V1_220127.indd 22 1/27/22 3:45 PM