Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.5
REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
8
OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
8.1
START THE MACHINE
1
2
1. Push the lock-out button (1) to the right side to
unlock the switch trigger.
2. Press the switch trigger (2).
Variable speed
To change the speed, increase or decrease the
pressure on the trigger. The further the trigger is pulled,
the greater the speed.
WARNING
WARNING
WARNING
English
8.2
STOP THE MACHINE
1. Release the switch trigger.
The lock-out button must be in the locked position
when the machine is not in use or is being
transported.
8.3
LED LIGHT
The LED light (6) illuminates when the trigger is
depressed.
It provides extra light for increased visibility.
8.4
OPERATE THE MACHINE
General cutting
1. Clamp the workpiece.
2. Mark the line of cut clearly.
3. Hold the machine firmly and switch it on.
4. Allow the motor to reach full speed.
5. Place the shoe against the workpiece.
6. Start the cutting work.
Make sure that the blade is not contacting the
workpiece until the motor reaches full speed.
8
WARNING
6
NOTE
Publicidad
