Husqvarna 2-20DT Global Manual De Usuario página 14

6. Use your other hand to operate the drive system
lever.
The quick release pin locks into position when the
drive system is engaged.
7. Close the drive chain cover.
8. To disengage the drivesystem, pull out the quick
release pin.
Abrasive valves
The abrasive valves controls the flow of the abrasive
shots to the blastwheels. The adjustment of the abrasive
valves is shown on the ammeters. Refer to
enclosure on page 5 .
The abrasive valves are adjusted with the abrasive
To operate the abrasive valves
control lever. Refer to
on page 14 .
To operate the abrasive valves
CAUTION:
valves when the blast motors are in
operation.
14
Electrical
Only open the abrasive
1. Pull the abrasive control lever to open the abrasive
valves and adjust the flow of abrasive shot.
2. Push the abrasive control lever to close the abrasive
valves and adjust the flow of the abrasive shot.
Abrasive seal
The abrasive seal makes sure that the abrasive stays
in the product during operation. The abrasive seal has
magnetic seals (A) on the sides and in front of the
2037 - 001 - 07.02.2023