Sanus Systems JFV65 Instrucciones De Montaje página 5

Step 1: Prepare the Top
Place the Top (o) upside down on a soft surface to lessen the chance of scratching. Insert 8 Cam Pins (b) and 8 Dowels (c) into the Top
as seen in Diagram 1. Proceed to tighten each Cam Pin with a Phillips screw driver. Next, orient the Barrel Nut (d) so the hole in its side
faces the hole in the back of the Top. Proceed to insert each Barrel Nut into the hole as shown in the Detailed View of Diagram 1. Then
thread each Barrel Nut Bolt (e) into the hole on the back of the Top, as pictured in the Detailed View of Diagram 1. Tighten each Barrel
Nut Bolt so they protrude a 1/4" from the Top.
Step 2: Add Outside Panels
Place each Cam (a) into each Outside Panel (s,t) as shown in Diagram 2. Make sure the arrow on the Cam is pointing toward the hole on
the outside as shown in Detailed View A. Place each Outside Panel on the Top (o), make sure Dowels (c) and Cam Pins (b) align with
the correct holes. The Channel on the back of the Top should be lined up with the Channel in the Outside Panel. Proceed to tighten the
Cams on each Outside Panel in a clockwise motion.
Diagram 1
Diagram 2
channel
channel
Detailed View
d
b
c
o
Detailed View
c b
Note: Cams should
be tightened in a
clockwise motion
e
a
o