Arregui AL011 Manual De Instrucciones página 15

AL011
Product kit
The magnetic door alarm system with vibration sensor consists of the
following elements, all of which are included in the product kit:
• 1 instruction manual
• 1 door alarm
• 1 magnetic sensor
• 1 remote control
Start-up
Pairing the alarm and remote control:
Step 1: Press the SET button located inside the alarm body. The LED light
will turn on.
Step 2: Press any button on the remote control to establish a connection.
The alarm will emit 2 beeps. This indicates that the alarm has been
successfully paired with the remote control.
Step 3: Repeat the previous 2 steps to pair the remote controls as needed.
Unpairing the alarm and remote control:
8 seconds. The red light will flash intermittently and then switch off. This
indicates that the alarm has been unpaired from the remote control.
PAIRED
Status light on.
Press the SET button for
3 secs.
Once all the devices have been paired, put the cover back on.
• 2 AAA batteries
• 1 CR2032 battery
• 3M adhesive
Press and hold the SET button for
UNPAIRED
Status light off.
Press the SET button for
8 secs.
En
15