Descargar Imprimir esta página

HSM StoreEx HDS 150 Instrucciones De Servicio página 26

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 54
english
Button(s) Action
Energy saving mode can be
switched on and off using
the control buttons
Press the Enter key to confi rm
the selection.
The time automatic shutdown
time can be set using the control
buttons.
Press the Enter key after setting
the time to confi rm the selection.
9. Troubleshooting
Shredded material container full
• The message "Container full" appears in the
display fi eld
• The status bar illuminates in red and the LED
on the operator control panel fl ashes in red.
The cutting unit is switched off after a brief
delay. To empty the shredded material
container, proceed as follows:
• Pull out the tray on the underside.
• Remove the container from the tray and empty
it.
• Insert the empty container into the tray.
• Push the tray in.
• Restart the cutting unit. Press the following control
buttons on the operator control panel:
Remove blockage
WARNING
Risk of cutting injuries from
the cutting unit
The cutting rollers of the cutting
unit can still cause injuries,
even if they are not running.
• Switch the system off before
troubleshooting.
• Wear protective gloves.
26
In the event of an overload or blockage, the drive
switches over automatically and briefl y reverses.
The cutting unit is then switched off automatically.
• Open the maintenance fl ap on the device.
• Manually remove the blockage by removing the
material via the maintenance fl ap.
• Restart the cutting unit. Press the following control
buttons on the operator control panel:
If any error messages whatsoever appear,
switch off the device and switch it on again
after waiting for one minute.
If the error message appears again,
notify HSM customer service.
10. Cleaning and maintenance
Cleaning
Cleaning the device
When cleaning, do not allow water to penetrate
the device.
Only with a soft cloth and a mild soapy water
solution to clean the device. Do not allow
water to penetrate the device when cleaning.
If water penetrates the device, notify HSM
customer service.
The use of:
• Scouring agents
• Benzine
• Petrol
• Thinners
is prohibited.
StoreEx HDS 150
NOTE
CAUTION
07/2022

Publicidad

loading