Publicidad
Idiomas disponibles
Idiomas disponibles
5. Make sure that the sausage skin is filled with slack, since the sausage
expands during boiling or frying and the skin may rupture.
6. If the first sausage reaches the required length, press the sausage
together at the end of the sausage attachment with your fingers.
7. Rotate the sausage once or twice.
8. Until you have developed a routine, you can turn the appliance off
after each sausage length.
2.2.3 Shaping cookies
1. Prepare an area to spread the cookies afterwards.
2. Use the rail (Fig. 2 & 3, No. 13) to form your prepared cookie dough
into different shapes.
3. Slide the rail into the cookie attachment after attaching the worm
casing with cookie attachment (Fig. 2 & 3, No. 12) on the appliance.
4. Set it to the desired cookie shape.
3. Blender
3. 1 Check before blender assembly (see Fig. 4)
1. Check the pre-assembly! Safety ring (Fig.4, No. 1c), sealing ring
(No. 1d), blade block (No. 1e) and cup base (No. 1f) must be assembled
in correct order.
2. Never forget to place the sealing ring on the blade assembly;
otherwise the mixing container will leak.
3. Do not attach the cup base askew.
4. The open side of the safety ring is locked with the cup base.
3. 2 Assembly and operation of blender
1. Before placing the blender make sure the power cord is disconnected
2. Attach the mixing bowl without tool.
3. Cover the worm casing connector with front cover :
- Set the connector ring (Fig. 2, No. 14) to OPEN position.
- Attach the cover to the connector ring.
- Turn the connector ring with the cove towards LOCK position.
4. Remove the blender safety cover (Fig. 1, No. 21) from the mixing
drive shaft:
Press the cover in the direction of LOCK arrowhead and lift the
blender safety cover at the same time.
5. Cut all ingredients in small pieces.
6. Fill the ingredients into the mixing jar. Observe the maximum capacity.
7. Press the lid (Fig 4, No. 1b) down on the mixing jar. The mixing jar
Publicidad
