Publicidad
Idiomas disponibles
Idiomas disponibles
REAR PANEL
9. Power switch.
10. RJ45 port to cascade another remote paging microphone.
11. RJ45 port to communicate with ZZONE series amplifier.
12. Microphone volume control.
13. Aux input.
14. Priority & Mic ID dipswitch.
100V LINE SYSTEM
For 100V line systems, connect the amplifier to the first speaker in the system using double-
insulated speaker wire which has adequate current rating to handle the total output of the
amplifier. Connect the "100V" output terminal to the positive (+) connection of the speaker
and "COM" output to the negative (-) connection of the speaker. Connect further speakers
in parallel to the first speaker with all positive terminals and connected together and all
negative terminals connected together as shown below.
A 100V line speaker system can comprise of many speakers connected together. The
determining factor for how many speakers can be used on a single amplifier is the power
rating. For most purposes, it is advised to connect as many speakers as needed with a
combined wattage of no more than 90% of the amplifier's output power rating.
The terminals of a 100V speaker are connected to a transformer and in some cases, this
transformer may be "tapped" for different power ratings. These tappings can be used to
adjust the wattage (and output volume) of each speaker in the system to help achieve the
ideal total power of the system for the amplifier. The mixer amplifier is featured of 6 speaker
zone outputs, either one of six zone or total six zone power loading shall be equivalent or no
higher than the rated power of the amplifier.
7
Publicidad
