Hilti TE DRS-5 Manual De Instrucciones página 19

With TE5-22
5 Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Fitting the dust removal module
1. Move the forward/reverse switch on the rotary hammer drill to the middle position.
2. Remove the depth gauge.
3. Turn the auxiliary handle to a position where it is not in the way.
4. Hook the dust removal module into the locking pins on the rotary hammer drill.
When hooking the module into position, be sure to pass the accessory tool of the rotary hammer
drill through the extraction head of the dust removal module.
5. Press the electrical interface into the rotary hammer drill until the dust removal module engages with an
audible click.
6. Check that the dust removal module is correctly engaged.
5.2 Removing the dust removal module
1. Move the forward/reverse switch on the rotary hammer drill to the middle position.
2. Press and hold down the catch on the dust removal module.
3. Pull the electrical interface out of the rotary hammer drill.
4. Unhook the dust removal module from the locking pins on the rotary hammer drill.
5.3 Adjusting total travel
1. Press and hold down the release for the total travel adjuster.
2. With the accessory tool fitted, press the rotary hammer drill against the working surface until the
accessory tool is in contact with the working surface.
▶ Total travel is set to the length of the accessory tool.
3. Let go of the release for the total travel adjuster.
5.4 Adjusting the depth gauge
If drilling depth has to be exact, drill test holes to establish the correct depth.
1. Press and hold down the release of the depth gauge.
2. Slide the depth gauge to the desired drilling depth.
3. Let go of the release of the depth gauge.
6 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
*2354048*
TE-CX X" x 8" 5.3 in
TE-CX X" x 6" 3.2 in
2
3
4
5
2354048 English 13