Westinghouse WPac14000s Manual Del Usuario página 14

OPERATION
Heat Mode (WPac14000h Only)
In this mode, warm air flows out of the air outlet grille.
The display will show the set temperature.
• Press the MODE button ( ) until the "Heat" LED is lit.
• Select a temperature between 55℉ and
81℉ (13°C and 27°C) by pressing the UP
( ) or DOWN ( ) button.
• Select your desired fan speed by pressing the FAN
button ( ). Choose between High, Low, and Auto. Re-
fer to corresponding LEDs above the FAN button ( ).
NOTE: During heating, water is pulled from the air and
collected inside the unit. Periodically or continuously
drain the tank as described in the Care and
Maintenance section. If the error code "ft" (full tank)
appears in the display, drain the tank immediately.
(Refer to Error Codes later in this section.)
Smart Mode
In this mode, the appliance automatically chooses
whether to operate in cool, heat (WPac14000h Only),
or fan mode.
• Press the MODE button ( ) until the following imag-
es appear in the display.
• Select your desired fan speed by pressing the
FAN button ( ) . Choose between High, Low, and
Auto. Refer to corresponding LEDs above the FAN
button ( ).
NOTE: The unit operates in heat mode (WPac14000h
Only) when the room temperature is below
20℃(68℉), fan mode when the room temperature
is from 68℉ (20℃) to 73℉(23℃), and cool mode
when the room temperature is above 73℉ (23℃).
FIG. 22
G
H
A
A - TIMER Button
B - FAN SPEED Button
C - DOWN Button
D - UP Button
14 | English
I
C
B
E - MODE Button
F - ON/OFF Button
G - Timer LED
H - Wi-Fi LED
UP/DOWN BUTTONS (
Press the UP ( ) or DOWN ( ) button to select a
temperature in cool or heat mode.
Temperature Units
The temperature can be displayed in Fahrenheit or
Celsius. To change the units, start the appliance then
press and hold both the UP ( ) and DOWN ( ) buttons
for three seconds.
Fahrenheit
FAN Button ( )
Press the FAN button ( ) to cycle between fan speeds in
cool, fan, heat, and smart mode.
TIMER Button ( )
Use the TIMER button ( ) to program the air conditioner
to start or stop at a certain time.
Timer ON
• Turn on the appliance and select your desired mode
and setting. For example, you may select dry mode
with high fan speed.
• Turn off the appliance.
• Press the TIMER button ( ) and wait for the display
to flash.
• Use the UP ( ) or DOWN ( ) button to set the time
before the appliance starts. The timer can be adjust-
ed in increments of 30 minutes up to 24 hours.
• After setting the timer, wait five seconds. The timer
LED, above the TIMER button ( ), should light indi-
cating the countdown has started.
J
K
D
I - Fan Speed LEDs (High, Low, Auto)
J - Display
K - Mode LEDs (Cool, Fan, Dry, Heat)
L - Sleep LED
)
Celsius
L
F
E