Descargar Imprimir esta página

Westinghouse WPac14000s Manual Del Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
NOTE: The Timer ON function can be cancelled by
pressing the TIMER button ( ) after the timer has
been set. If the function is cancelled, the timer LED
will turn off.
Timer OFF
• While the appliance is running, press the TIMER but-
ton ( ) and wait for the display to flash.
• Use the UP ( ) or DOWN ( ) button to set the time
before the appliance stops. The timer can be adjust-
ed in increments of 30 minutes up to 24 hours.
• After setting the timer, wait five seconds. The timer
LED, above the TIMER button ( ), should light indi-
cating the countdown has started.
NOTE: The Timer OFF function can be cancelled by
pressing the TIMER button ( ) after the timer has
been set. If the function is cancelled, the timer LED
will turn off.
ERROR CODES
This appliance has a self-diagnostic system to identify a
number of malfunctions. Error messages appear on the
display as shown.
ERROR CODE
PROBE FAILURE
(Damaged Sensor)
FULL TANK
(Condensate Water
Tank Full)
ADDING/REPLACING REMOTE BATTERIES
See Figure 23.
l Slide the battery cover off of the remote control.
l Install new AAA batteires (1.5V) into the remote control
according to their polarity.
l Replace the battery cover.
USING THE REMOTE CONTROLLER
See Figures 24 - 25.
Use the remote control to operate the air conditioner
from a distance. The remote must be within 23 ft.
(7 meters) away from the appliance.
ON/OFF Button ( )
Press the ON/OFF button ( ) to turn the appliance on and
off. When activated, the unit will return to the last mode
that was used.
UP/DOWN BUTTONS (
Press the UP ( ) or DOWN ( ) button to select a
temperature in cool or heat mode.
SOLUTION
Unplug the appliance and
contact customer service
at 1 (855) 944-3571.
Drain the collected water
as described in the Care
and Maintenance section.
)
Child Lock
• To activate the child lock, press and hold both the Up
( ) and Down ( ) buttons for three seconds. While
the child lock is active, the buttons on the remote
control will be inactive. When active the child lock
icon will dispay in the remote display.
• To deactivate the child lock, press and hold both the
Up ( ) and Down ( ) buttons for three seconds.
FIG. 23
C
A - Batteries (AAA)
B - Cover
C - Remote Control
FIG. 24
A - Display
B - FUNCTION Button
C - ON/OFF Button
D - UP Button
E - TIMER Button
F - SWING Button
G - DOWN Button
H - UNIT CHANGE Button
I - SLEEP Button
J - FAN Button
A
A
C
D
E
I
J
English | 15
B
B
F
I
G
H

Publicidad

loading

Este manual también es adecuado para:

Wpac14000h