Technical Information; Installation Considerations - Hansgrohe Axor Starck 10101001 Instrucciones De Montaje / Manejo / Garantía

Tabla de contenido

Publicidad

English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate
Hole size in mounting surface
Max. depth of mounting surface
Battery
Automatic shutoff
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
**This is the maximum amount of time the faucet will run
while a hand is within range of the sensor.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
• Flush the hot and cold supplies thoroughly
before installing the faucet. Damage to the
faucet caused by debris is not covered under the
warranty.
• The hot and cold supplies should be of equal
pressure.
• The faucet should not be used with a continuous
flow water heater.
• Do not install the faucet on a sink with a raised
edge.
• Strong light sources should not shine directly on
the sensor window of the faucet.
• The faucet should only be used with the battery
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
1.5 GPM
1⅜"
1⅝"
CR-P2 / 6 V Lithium
after 1 minute**
pack supplied by Hansgrohe. Do not attempt to
use any other battery pack.
• The faucet incorporates automatic range adjust-
ment -- the sensor automatically adjusts itself to
local conditions (lavatory, brightness, etc.)
• The distance between the switch on/off point
to the faucet is approx. 6¼" - 8" under normal
conditions. The detection area may be less for
dark, non-reflective objects, or greater for bright,
highly reflective objects.
• If the sink is very small or highly reflec-
tive, follow the range reduction instruc-
tions. When the faucet is in reduced range
mode, the LED in the sensor window will flash
while the faucet is not in use.
• Drops of water or condensation on the sensor
window may cause the faucet to run.
• If the LED in the sensor window flashes while the
faucet is in use, the battery is low, but the faucet
may still be used. If the LED stays on, the faucet
will not run, and the battery must be changed.
• The spray pattern will be unattractive
immediately after installation or service,
due to air in the faucet. After the faucet
is used 10 - 15 times, the spray pattern
will clear.
• At the start of operation, or after maintenance,
function of the faucet may be delayed due to
reflections during adjustment of the operating
distance. The faucet will automatically calibrate
itself. The self-calibration will start after 10-15
minutes.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Starck 10106001Starck x 10170001Starck x 10175001

Tabla de contenido