Tyco FC410SIO Manual De Instrucciones página 4

FC410SIO
being installed by using the programming port on
the front cover (see Fig. 3).
Note: Once the address has been programmed,
take note of the device location and address
number, to include on site drawings.
Note: This device uses one address only on the
loop.
Cabling
Cables are to be selected in accordance with the
system design document and the requirements
of the applicable standards.The maximum sec-
tion of the cable that can be connected at any
one terminal is 2.5mm
ted based on the characteristics of the cable and
the load.
Ordering information
FC410SIO Single Input / Output Module
FC470CV Ancillary Cover
4/12
2
. The section is calcula-
Recycling information
Customers are recommended to dispose of their
used equipments (panels, detectors, sirens, and
other devices) in an environmentally sound man-
ner. Potential methods include reuse of parts or
whole products and recycling of products, com-
ponents, and/or materials.
Waste electrical and electronic
equipment (WEEE) directive
In the European Union, this label indi-
cates that this product should NOT
be disposed of with household
waste. It should be deposited at an
appropriate facility to enable
recovery and recycling.
The manufacturer reserves the right to change
the technical specifications of this product
without prior notice.
Fixing instructions Doc. version 5.0
FireClass