Publicidad
Idiomas disponibles
Idiomas disponibles
USE AND OPERATION (CONTINUED)
REMOTE CONTROL
All key functions can be accessed from the remote control.
Power Control
ON / OFF
Timer / Temperature Set Control
•
Under timer mode, press
to adjust the time setting for
1 hour intervals.
•
Timer setting is available from 1
- 24 Under cooling and heating
mode, press
and
to up or
down the temperature.
Swing Control
ON / OFF
Sleep Control
ON / OFF
Note:
•
Battery Installation: Remove the cover on the back of the remote control and insert two AAA
batteries with + and - pointing in the proper direction according to the polarity markings.
Caution:
•
Use only two AAA or IEC R03 1.5V batteries.
•
Remove the batteries if the remote control is not in use for a month or longer.
•
All batteries should be replaced at the same time, do not mix with old batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
•
Properly dispose of used batteries.
This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment info an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
and
EN
Mode Control
Press
to change the operation mode
in the order of:
Cooling
Dehumidifying
Fan Speed Control
• HIGH • MED • LOW
°C / °F Control
Press to switch temperature between
Centigrade and Fahrenheit.
*Applicable for models with Heating feature only.
10
Heating*
Fan
Publicidad
