Televes DVB S2-QAM Manual De Instrucciones página 40

User manual
WARNING: To be able to control a headend
remotely each device should have a diffe-
rent address (1 to 254). It is the responsibi-
lity of the installer to make sure that there
are not duplicated CDC addresses in the
control bus.
To carry out a modification the
be pressed until the desired parameter flas-
hes. Then the correspondent parameter can
be modified by pressing and
b.- Selection of operator ID
This menu enables the selection of the
"operator_id" field which will be included in
the output transport stream. This menu will
only be shown if such field exists in the input
transport stream.
operator_id
Select the
operator_id
OX1239
c.- Version menu
This menu shows the user the versions of
the unit's firmware and transport stream
processing module (FPGA).
VERSIONS
Unit:
1.00
FPGA:2.03
d.- Language selection menu
key must
The last extended menu allows the selection
of the menus language (English/Spanish).
.
By pressing
different languages.
5.3.- PARAMETERS SAVING
Once a parameter is modified to the desired
value in any menu (normal or extended), to
save the settings press
seconds. The display will show the following
indication:
LANGUAGE
English
or you switch between
for three
40
DVB S2-QAM TS-PROC
Saving
setting and
restarting
...
If the configuration paremeters are modified
but not saved the previous configuration is
retrieved after 30 sec. in other words the
changes are discarded.
5.4.- LEDs STATUS
Finally, the LEDs indicate the following opera-
ting conditions:
- Left LED (A) = Sufficient input signal
level (for guidance)
- Central LED (B) = Connection of the
COFDM demodulator
- Right LED (C) = Connection of the QAM
modulator
The LEDs that are illuminated indicate correct
operation. If any of them go out, this is an
indication of faulty behaviour.