Publicidad
Idiomas disponibles
Idiomas disponibles
See the type plate or technical data for
the connection values.
1. Unwind the mains cable and place it
on the ground.
2. Plug the mains plug (GFCI) into the
socket.
Water connection
Connection to a water line
WARNING
Health risk from return flow of con-
taminated water into the drinking
water network.
Observe the regulations of your water
supply company.
1. Check the feed pressure, input tem-
perature and input amount of the
water supply.
2. Connect the system separator and
water connection of the device with
a hose (minimum length 7.5 m, min-
imum diameter 3/4").
The supply hose is not included in
the scope of delivery.
3. Open the water inlet.
Venting the device
1. Open the water inlet.
2. Remove the high-pressure nozzle.
3. Switch on the device.
4. Allow the device to run until the es-
caping water is free of air bubbles.
5. Switch off the device.
6. Fit the high-pressure nozzle.
Operation
DANGER
Risk of explosion!
Do not spray flammable liquids.
If the device is used in hazardous ar-
eas (e.g. filling stations), the corre-
sponding safety regulations must be
observed.
Opening / closing the high-
ressure gun
1. Push back the safety lock and actu-
ate the trigger.
The high-pressure gun opens.
2. Release the trigger and push the
safety lock forward.
Then the high-pressure gun closes.
High-pressure operation
Note
The device can be operated vertical-
ly.
The device is equipped with a pres-
sure switch. The motor only starts
up when the high-pressure gun is
open.
The high-pressure hose should be
kept away from sharp edges.
1. Unfold the high-pressure hose com-
pletely from the hose reel.
2. Open the water supply.
3. Set the power switch to "1".
4. Open the safety lock of the high-
pressure gun.
5. Aim the high-pressure gun at the ob-
ject to be cleaned .
6. Open the high-pressure gun and
start the cleaning operation.
Operation with detergent
Note
A foam lance (optional) is needed for
operating with detergent.
Publicidad
