Horizon Global 118784 Instrucciones De Instalación página 4

6. Route the 4-Flat harness rearward a long back of the bumper fascia to
the center of the vehicle. Secure the remainder of the 4-Flat harness
with the cable ties provided, to prevent damage or rattling and being
careful to avoid any areas that would pinch, cut or melt the wires.
If routing the wire thru a grommet and along the exterior of the vehicle,
be careful to avoid any hot pipes, heat shields, the fuel tank or any
other points that may pinch or break the wire.
7. Mount the 4-Flat end in an accessible location with a bracket or
electrical box (not included).
8. Reinstall the Plastic cover (if Removed), Being care not to break any
plastic securing pins.
©2023 Horizon Global™ Corp
All connections must be complete for the T-One® T-Connector to function
properly. Test and verify installation with a test light or trailer once
installed. For initial test, reset vehicle electrical system by temporarily
removing the key from the ignition.
Overloading circuits can cause fires. DO NOT exceed stated product
ratings. Read vehicle's owner's manual & instruction sheet for additional
information.
Sheet 4 of 15 118784-NP 3/3/2023 Rev. A