Publicidad
Idiomas disponibles
Idiomas disponibles
consideration of polarity (+/-). Close the battery compartment with the battery door again.
2.
Connect the AC/DC adapter (HX0180500150D2E) with the main station to an household
power outlet. Display will be fully displayed for a short time and then start operation.
3.
All display elements will light up for a short time and then the station will start to search for the
outdoor sensor signal.
Back-up batteries (optional):
1.
Open the battery compartment of the main station and insert 3 x AAA batteries under
consideration of polarity (+/-). Close the battery compartment with the battery door again.
Outdoor sensor reception:
Outdoor reception icon
After powering, the station automatically searches for the outdoor sensor signal.
The strength signal icon will flash until the sensor signal is received or for 3 minutes if no
signal available.
Hold the CH/+ button for 2 seconds if no signal was received after 3 minutes or to manually
search for the sensor of the selected channel. Then press the TX button on the sensor to
manually send the signal.
In case of further reception problems: please repeat the steps of the initial operation again.
Note:
The outdoor sensor needs to be placed away from direct sunlight and rain.
Automatic reception of DCF:
DCF RECEPTION ICON with full signal strength will appear on screen if the reception of
radio-controlled time is successful.
The tower icon is displayed permanently when the display has received the DCF signal.
No tower icon displayed. The station was unable to receive a signal at this time.
Reposition the display for better signal reception or try again at bedtime.
Daily at 1:00,2:00,3:00,4:00,5:00 the clock will automatically receive the time, once received
the clock will only search for the signal again on the following day.
If the unit received DST signal, the unit will display "DST" icon. If the unit did not received
Publicidad
