Publicidad
Idiomas disponibles
Idiomas disponibles
Deactivating the ice dispenser
Press the ICE OFF button, the icon 7 will light up when the mode is activated or turn
off when the mode is deactivated.
Dispenser
Press the DISPENSER button to access the water or ice dispensing selection,
which will change according to the sequence "Ice cube dispenser/Crushed ice
dispenser/Water dispenser/None". The corresponding icon will illuminate on the
panel. When the refrigerator is running, the filter usage time is accumulated.
Icon 6 will illuminate after 150 days and will flash after 180 days. Please note
that the filter change warning time is approximate and should be adjusted to
your actual water consumption. The filter has a 1136 litre capacity and it is
advisable to change it every 6 to 12 months. After the filter has been changed,
press and hold DISPENSER for 3 seconds to reset the water filter service time.
Memory function in case of power failure
In the event of a power failure, the operating mode will be stored and will be
restarted when power is restored.
Door opening alert
When the door is opened, a buzzer will sound, and if the door is not closed within 2
minutes, an alert will sound once per second until the door is closed.
Error Codes
The display may show one of the following codes to indicate an appliance fault.
Although the refrigerator may continue to cool despite displaying these errors, the
user should call for service to ensure optimal operation of the refrigerator.
E0: Icemaker error
E1: Refrigerator temperature sensor failure
E2: Freezer temperature sensor failure
E5: Error in the defrost sensor detection circuit
E6: Communication error
E7: Error in the room temperature probe
EE: Icemaker sensor circuit error
EH: Humidity sensor error
3.3 Ice and Water Dispenser
During the production of ice cubes and crushed ice, with the flow of water into
the ice compartment and the ice crusher, noises may occur, the water valve will
emit a vibrating sound. These sounds are normal.
When the ice is removed, it may squeak if it accumulates and sticks together. In
this case, remove the ice container and separate the ice that has clumped
together by pressing it with a wooden or plastic spoon.
To prevent the ice machine motor from overheating, do not scoop ice for more
than 1 minute at a time and wait a few moments for the motor to cool down, or
scoop ice directly from the bin if a large quantity is required. The Cleaning the Ice
Bin section explains how to remove the ice bin. If there is not enough ice in the
dispenser, you will not remove any; wait for it to make more ice.
To prevent the ice from tasting or smelling bad, clean the ice bin frequently.
The ice and water dispenser can only be used with the freezer door closed. If the
process is running and the door is opened, it will automatically stop.
Minimum and maximum inlet pressure: 0.8-0.15MPa.
16
V.2
Publicidad
