Publicidad
Idiomas disponibles
Idiomas disponibles
not match the mounting hardware of the power tool will run out of balance, vibrate excessively and may cause loss of control.
g)
Mandrel mounted wheels, sanding drums, cutters or other accessories must be fully inserted into the collet or chuck. If the mandrel is insuffi-
ciently held and/or the overhang of the wheel is too long, the mounted wheel may become loose and be ejected at high velocity.
h)
Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheels for chips and cracks, sanding drum for
cracks, tear or excess wear, wire brush for loose or cracked wires. If power tool or accessory is dropped, inspect for damage or install an
undamaged accessory. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating acces-
sory and run the power tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test time.
i)
Wear personal protective equipment. Depending on application, use face shield, safety goggles or safety glasses. As appropriate, wear dust
mask, hearing protectors, gloves and workshop apron capable of stopping small abrasive or workpiece fragments. The eye protection must be
capable of stopping flying debris generated by various operations. The dust mask or respirator must be capable of filtrating particles generated
by your operation. Prolonged exposure to high intensity noise may cause hearing loss.
j)
Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal protective equipment. Fragments
of workpiece or of a broken accessory may fly away and cause injury beyond immediate area of operation.
k)
Hold power tool by insulated gripping surfaces only, when performing an operation where the cutting accessory may contact hidden wiring or
its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an
electric shock.
l)
Always hold the tool firmly in your hand(s) during the start-up. The reaction torque of the motor, as it accelerates to full speed, can cause the
tool to twist.
m)
Use clamps to support workpiece whenever practical. Never hold a small workpiece in one hand and the tool in the other hand while in use.
Clamping a small workpiece allows you to use your hand(s) to control the tool. Round material such as dowel rods, pipes or tubing have a
tendency to roll while being cut, and may cause the bit to bind or jump toward you.
n)
Position the cord clear of the spinning accessory. If you lose control, the cord may be cut or snagged and your hand or arm may be pulled into
the spinning accessory.
o)
Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the
power tool out of your control.
- 04 -
Publicidad
