Heltun HE-TPS02 Guia De Inicio Rapido página 10

DISASSEMBLY
1.
To disassemble, ENSURE POWER IS SWITCHED OFF at the main circuit breaker AND THE LCD SCREEN IS BLANK.
2.
To remove the HE-TPS02 touch panel unit grasp rmly at the bottom and pull backwards while tilting outwards until all tabs disconnect.
3.
Remove screws from backplate and disconnect the wires by inserting a small Phillips-head screwdriver into the slot beneath each wire
and unscrewing to release.
Z-WAVE NETWORK
The HE-TPS02 may be operated in any Z-Wave network with other Z-Wave certi ed devices from other manufacturers. The HELTUN
HE-TPS02 will act as a 'repeater' for other devices regardless of manufacturer or brand to increase the reliability of the overall network.
Security
S0, S2 unauthorized, and S2 authorized Inclusion Modes are supported. If you use the S2 authorized Inclusion Mode the security key
should be used during the inclusion process. The Security Key is printed on a card located with this quick start guide and also on the
HE-TPS02 backplate (see Figures 9 & 10).
Note: Be sure to save this key. Without the key, it is impossible to perform an Inclusion in S2 authorized mode.
SmartStart
SmartStart-enabled products can be added to a Z-Wave network by scanning the Z-Wave QR Code shown on the product with
gateways/controllers that provide for SmartStart inclusion. In this case, no further action will be required and the SmartStart product will
be added automatically within ten minutes of being turned on in the vicinity of a network.
To add the HE-TPS02 to the Z-Wave network using SmartStart:
1.
Set the main controller in Security S2 Authenticated "Add Mode".
2.
Input the Touch Panel Switch 'Duo' DSK to the controller (or scan the QR code).
3.
Power on the device.
4.
Wait for the adding process to complete.
5.
Successful adding will be con rmed by a message on the Z-Wave controller.
Note: The device security code (DSK) and SmartStart QR code are printed on the HE-TPS02 back panel plus on the included Security Card
(see Figures 9 & 10).