Heltun HE-TPS02 Guia De Inicio Rapido página 11

Including the HE-TPS02 to an Existing Z-Wave Network
To add the HE-TPS02 to an existing Z-Wave network (i.e. "inclusion"), do the following:
1.
Start the Inclusion Mode from the gateway/controller.
2. To start the inclusion process on the HE-TPS02, simultaneously press the two upper hidden touch buttons (see Figure 8) and hold them
for three seconds.
3.
All buttons will then sequentially blink 'blue-red' .
4.
If the inclusion has been successful, all buttons will turn blue for three seconds.
5.
If the inclusion was not successful, all buttons will turn red for three seconds. In that case repeat the inclusion process.
Removing the HE-TPS02 from Z-Wave network
To remove the HE-TPS02 from a Z-Wave network (i.e. "Exclusion"), do the following:
1. Start the Exclusion Mode from the gateway/controller.
2. To start the exclusion process on the HE-TPS02, simultaneously press the two upper hidden touch buttons (see Figure 8) and hold them
for three seconds.
3.
All buttons will sequentially blink blue-red.
4.
If the exclusion has been successful, all buttons will turn red for three seconds.
5.
If the exclusion was not successful, all buttons will turn blue for three seconds. In that case repeat the exclusion process.
Note: If the HE-TPS02 has previously been part of a Z-Wave network and not Excluded since, Inclusion is not possible without rst
performing an Exclusion or Factory Reset procedure.