Hart HGNV01BTL 20V Manual Del Operador página 8

OPERATION
To use the clamps:
 Make sure the inverter is turned off.
 Connect the red cable to the power source's positive (+)
terminal first, then connect the black cable to the power
source's negative (-) terminal. Make sure all connections
are tight.
 Connect the cables to the battery using the car battery
clamps. Connect the red cable clamp to the positive
battery lug (+) and the black cable clamp to the negative
battery lug (–).
NOTE: Do not allow the inverter to hang by its leads when
the clamps are connected to the battery.
CAUTION:
To avoid damaging the inverter or blowing the fuses,
always remove the test leads from the battery.
USING THE POWER INVERTER
See Figure 6.
When needed, an internal cooling fan will run to regulate the
unit's operating temperature. If the fan is running, always
wait for it to stop before you disconnect the battery pack
from the inverter.
 Press and hold the power button for 1.5 seconds to turn
the inverter ON. The LED will light up green when ready
to use.
MAINTENANCE
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
 Plug devices you want to power or charge into the
inverter's USB ports and/or 120 volt receptacle.
 If the power button LED blinks red then turns off, the
inverter may be overloaded. Disconnect your device,
make sure your battery pack is sufficiently charged to
power your device, then press the button to turn the
inverter back on. Reconnect your device and try again.
If the fault condition immediately reoccurs, the item
being powered exceeds the capacity of the inverter.
 If the power button LED turns solid red, the power
source is overheated. Allow the unit to cool until the
LED blinks red, then press the button to reset the power
source
 If the power button LED flashes yellow, the battery pack
needs to be recharged.
 Tap the power button one time to toggle between out-
put power (watts) and input power (volts) on the digital
display.
 To use the worklight, press the light button. Press the
light button again to turn the worklight off.
NOTE: The inverter must be on for the worklight to
function.
 When finished, disconnect your device and press the
power button indicator again for 1.5 seconds to turn off
the inverter.
NOTE: When needed, an internal cooling fan will run to
regulate the unit's operating temperature. If running, always
wait for the fan to stop before you disconnect the battery
pack from the inverter.
WARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which may
result in serious personal injury.
STORING THE POWER SOURCE
Store indoors, without battery pack, in a dry, locked-up
place, out of the reach of children. Keep away from corrosive
agents such as garden chemi cals and de-icing salts.
REPLACEMENT PARTS
The following replacement parts may be ordered by calling
our customer service department at 1-800-776-5191:
Car Battery Clamps Cable................................. 290426042
Mounting Bracket .............................................. 638700062
6 – English