Makita DHR183 Manual De Instrucciones página 10

Adjust the depth gauge by moving it back and forth
while pressing the lock button. After the adjustment,
release the lock button to lock the depth gauge.
NOTE: Make sure that the depth gauge does not
touch the main body of the tool when attaching it.
Dust cup
Optional accessory
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Model
Dust cup 5
Dust cup 9
Fig.14
► 1 . Dust cup
Dust cup set
Optional accessory
Installing the dust cup set
NOTICE:
Do not use the dust cup set when drill-
ing in metal or similar. It may damage the dust cup
set due to the heat produced by small metal dust or
similar. Do not install or remove the dust cup set with
the drill bit installed in the tool. It may damage the
dust cup set and cause dust leak.
Before installing the dust cup set, remove the drill bit
from the tool if installed.
1.
Loosen the thumb screw on the side grip.
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
1
2. Install the dust cup set so that the claws of the
dust cup fit in the slits on the side grip.
1
Fig.15
► 1 . Dust cup set 2. Side grip
3.
Install the side grip so that the groove on the grip
fit in the protrusion on the tool. Tighten the thumb screw
to secure the side grip.
1
Fig.16
► 1 . Side grip 2. Groove 3. Protrusion
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
1
Fig.17
► 1 . Dust cap
10 ENGLISH
2
2
3