Makita DHR183 Manual De Instrucciones página 12

3. Be sure that the grooves around the cap well fit in
the lips of the upper opening of the attachment unit.
Tool hanger
Optional accessory
CAUTION:
Do not use damaged tool hanger
and screw. Before use, always check for dam-
ages, cracks or deformations, and make sure that
the screw is tightened.
CAUTION:
Install or remove the tool hanger
on a stable table or surface. Be sure to use the
screw provided with the tool hanger only. After
installing the tool hanger, make sure that the tool
hanger is securely installed with the screw.
CAUTION:
Do not remove the battery car-
tridge while hanging the tool. The tool may fall if the
screw is not tightened.
The tool hanger is intended for connecting the lanyard
(tether strap).
Before installing the tool hanger, remove the rubber cap
from the screw hole in the mounting bracket. Insert the
square nut under the bracket. Tighten the tool hanger
with screw in place.
2
4
3
Fig.23
► 1 . Rubber cap 2. Mounting bracket 3. Square nut
4. Tool hanger 5. Screw
Safety warnings about connecting
lanyard (tether strap) to the tool
hanger
Safety warnings specific for use at height
Read all safety warnings and instructions. Failure
to follow the warnings and instructions may result in
serious injury.
Always keep the tool tethered when working
1.
"at height". Maximum lanyard length is 2 m
(6.5 ft).
The maximum permissible fall height for lan-
yard (tether strap) must not exceed 2 m (6.5 ft).
2. Use only with lanyards appropriate for this tool
type and rated for at least 6.0 kg (13.2 lbs).
3.
4.
5.
6.
7.
8.
9.
10. Do not carry the tool by the attachment device
11.
12. Do not attach lanyards to the tool in a way that
13. Avoid getting tangled in the lanyard.
1
14. Keep lanyard away from the drilling area of the
15. Use a locking carabiner (multi-action and
16. In the event the tool is dropped, it must be
17. Do not hang the tool on your waist. Heated tool
5
► 1 . Tool hanger 2. Lanyard (tether strap)
12 ENGLISH
Do not anchor the tool lanyard to anything on
your body or on movable components. Anchor
the tool lanyard to a rigid structure that can
withstand the forces of a dropped tool.
Make sure the lanyard is properly secured at
each end prior to use.
Inspect the tool and lanyard before each use
for damage and proper function (including
fabric and stitching). Do not use if damaged or
not functioning properly.
Do not wrap lanyards around or allow them to
come in contact with sharp or rough edges.
Fasten the other end of the lanyard outside
the working area so that a falling tool is held
securely.
Attach the lanyard so that the tool will move
away from the operator if it falls. Dropped tools
will swing on the lanyard, which could cause injury
or loss of balance.
Do not use near moving parts or running
machinery. Failure to do so may result in a crush
or entanglement hazard.
or the lanyard.
Only transfer the tool between your hands
while you are properly balanced.
keeps switches or trigger-lock (if supplied)
from operating properly.
tool.
screw gate type). Do not use single action
spring clip carabiners.
tagged and removed from service, and should
be inspected by a Makita Factory or Authorized
Service Center.
and its accessory may touch your skin and burn
injury result.
1
2
Fig.24