Ninja WOODFIRE OG701EU Instrucciones página 20

PARTS & ACCESSORIES
A Grill Plate
B A
Crisper Basket
C Smoke Box (pre-installed)
D Grease Tray
E Left and Right Assembly
Handles
C
F Socket Head Cap Screw
3.5mm x 16mm (4x) (pre-
assembled on handles)
G
Hex Key
E
H Pellet Scoop
I Assembled Main Unit
(power cord not shown)
F
J
Lid
G
K Control Panel
L ON/OFF Press
H
To order replacement or additional parts and accessories, visit ninjakitchen.eu
BEFORE FIRST USE
1 Remove and discard any packaging material and tape from the unit. Some stickers are to be permanently
kept on the unit, ONLY remove stickers with 'peel here'.
2 Remove all accessories from the package and read this manual carefully. Please pay particular attention to
operational instructions, warnings and important safeguards to avoid any injury or property damage.
3 Wash the grill plate and crisper basket in warm, soapy water, then rinse and dry thoroughly. The grill plate,
crisper basket and base unit are NOT dishwasher safe. NEVER clean the main unit in the dishwasher.
NOTE: The base liner underneath the bottom heating element may have some visible discoloration.
This is a result of our normal manufacturing process. The unit has not been previously used.
4 DO NOT use abrasive brushes or sponges on the cooking surfaces, as they will cause damage to the coating.
5
Plug into electrical socket and press the switch located underneath the left side of the control panel to the
ON position. (See Fig. A above).
6
To turn your product off, ensure the dial is rotated to the OFF position and the press switch is OFF.
NOTE: If unit won't turn on, check the residual current device (RCD) is fully plugged in and the reset button has
been pressed.
We recommend placing all accessories inside the grill and running it on GRILL, temp set to HI
for 20 minutes without adding food. This removes any residues. This is completely safe and not
detrimental to the performance of the grill.
38 ninjakitchen.eu
B
D
J
I
K
L (Fig. A)
BEFORE FIRST USE - CONTINUED
HANDLE INSTALLATION
1
Ensure the correct handle is being used on the left and right side. (Refer to Fig. A and note that the
handles have L and R stickers on the underside). A Hex key is taped onto the left handle (see Fig. A).
2
Place unit at edge of table (Fig. B) OR with lid still taped down, carefully place grill upside down by
holding the sides of the unit and the lid down. If tape has been removed, remove all accessories from the
grill and holding the sides of the unit and the lid down, place grill on top of top pulp tray piece to protect
unit (Fig. C).
3 Align each handle with tabs on base, then push up to set each handle in place (Fig. D). Use included Hex
key to tighten pre-assembled screws (2x) on each handle (Fig. E).
Fig. A
Fig. C
EXTENSION CORD
1 If using an extension cord, ensure it is suitable for use outdoors with outdoor appliances. Using
the incorrect cord could lead to the cord overheating, melting and/or a drop in voltage. A drop in
voltage can increase preheat times and impact cooking performance and/or cook times.
Fig. B
Fig. D
Fig. E
39
ninjakitchen.eu