Beko BUFR2715PSIM Manual Del Usuario página 10

Installation
3.1. Before Installation
• Before nstall ng, be sure the
open ng measurements are
suff c ent to rece ve the product
and that the appropr ate electr cal
and plumb ng connect ons are
present.
• Refer to the nearest Author zed
Serv ce Agent for nstallat on
of the product. To make the
product ready for use, make sure
that the electr c ty nstallat on
s appropr ate before call ng the
Author zed Serv ce Agent. If not,
call a qual f ed electr c an to have
any necessary arrangements
carr ed out.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least
12''(30cm) away from heat sources
such as hobs, heater cores and
stoves and at least 2''(5 cm)away
from electr cal ovens.
• Product must not be subjected to
d rect sun l ght and kept n hum d
places.
• Appropr ate a r vent lat on must
be prov ded around your product
n order to ach eve an eff c ent
operat on. If the product s to be
placed n a recess n the wall, pay
attent on to leave at least 2''(5 cm)
d stance w th the ce l ng and s de
walls.
• Do not nstall the product n places
where the temperature falls below
23 °F (-5°C).
3.2.Installing the
plastic wedges
Plast c wedges suppl ed w th the
product are used to create the
d stance for the a r c rculat on
between the product and the rear
wall.
1. To nstall the wedges, remove the
screws on the product and use the
screws suppl ed together w th the
wedges.
2. Insert the 2 plast c wedges onto
the rear vent lat on cover as
llustrated n the f gure.
3.3.Adjusting the feet
After mov ng the freezer nto place,
we recommend lower ng the feet to
secure the product n place. You can
also adjust the feet f the product s
not balanced. Tw st the feet n the
des red d rect on accord ng to the
llustrat on below. Adjust ng the feet
can also be used to al gn the doors.
10 / 20 EN
Freezer / User Manual