LUND 67500 Manual De Instrucciones página 10

EN
of the product not described in the manual.
Move the product only when cooled down, grasping the housing. Do not move the product
by pulling on the power cord.
The temperature at the place of installation and use of the product must be within the range
of +10 C ÷ +38 C, and the relative humidity must be below 90% without condensation.
O O
The product is intended for indoor use only. Do not expose it to precipitation or water
in any form.
Recommendations for connecting the product to the power supply
Before connecting the product to the power supply, make sure that the voltage, frequency
and performance of the power supply correspond to the values shown on the product's rating
plate. The plug must fi t into the outlet. It is forbidden to modify the plug or socket in any way
for the purpose of fi tting.
The product must be connected directly to a single socket of the power supply. It is forbidden
to use extension cords, adapters or double sockets. The power supply circuit must be fi tted
with a protective conductor and at least a 16 A protective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation,
the power cord must always be fully extended and the position of the power cord must be
set so that it does not become an obstacle during product operation. The power cord shall
not be placed in a manner that would pose a risk of tripping. The power supply socket should
be located in a place where it is always possible to quickly remove the product power cord
plug. Always pull the power cord by the plug housing when unplugging it, never by the cord.
If the power cord or the plug is damaged, immediately disconnect it from the power supply
and contact an authorised service centre of the manufacturer for replacement. Do not use the
product with a damaged power cord or plug. The power cord or plug cannot be repaired and
must be replaced with a new one that is free of defects if these components are damaged.
Instructions for use
WARNING! Metal parts and housing can be hot after use. Do not touch them, as it may
cause severe burns. Allow product elements to cool down. Use gloves that protect against
high temperatures if you need to move them before they cool down.
Make sure that the fl oor near the place of use of the product is not slippery. This will prevent
slipping, which can cause serious injuries.
Do not place too thick bread slices inside the toaster. Contact of the bread with the product
heater may lead to fi re.
Observe the bread at all times and prevent it from burning during its preparation. Bread left
unattended can burn, which can cause fi re and serious burns.
If the product is equipped with a crumb tray, empty it at the frequency and in the manner
specifi ed in the user manual.
Never place bread or other products on top of the toaster. Bread can only be toasted inside
the toast slot. Covering the top of the toaster can cause the toaster to overheat, which can
damage the toaster and cause fi re and/or electrical shock.
If the bread gets stuck inside the hot toast slot, it should not be removed with hands or metal
O R I G I N A L I N S T R U C T I O N S
10