Publicidad
Idiomas disponibles
Idiomas disponibles
2.3.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected product will do a better and safer job for which it was
designed.
b)
Keep unused product out of the reach of children and anyone unfamiliar with
the device or this manual. Products are dangerous when used by
inexperienced users.
c)
Keep the product in good working order. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
have the device repaired before use.
d)
Keep the product out of the reach of children.
e)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
f)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
g)
Do not process two workpieces at the same time.
h)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
i)
Do not tamper with the device to alter its performance or design.
j)
Do not overload the device.
k)
Long pieces must be supported and positioned steadily during processing.
l)
The processed element shall be aligned horizontally and perpendicularly to the
blades of the device.
m) Do not touch the blades when operating the device.
n)
Do not keep hands closer than 20 cm from the blades of the product when
holding the processed element.
o) Do not use on materials thicker than recommended. If resistance is
encountered during cutting, check the sharpening of the blade. If the blade is
sharp enough, resistance means that the material is too thick.
p) Check the sharpness of the blade regularly. A blunt tool significantly reduces
the efficiency of work.
q) Do not leave the device in a place accessible to children or bystanders! Store
with the blade locked/closed after use.
r)
The handle cannot be used to lift the unit.
s)
Treated panels should be clean.
t)
The unit uses a blunt blade designed for floor panels. The blade does not chip
the material. If necessary, align the edges of the blade with a sharpening stone.
Publicidad
