Party Light & Sound PARTY-200UHF Manual De Instrucciones página 29

Per un buon funzionamento, non posizionare il ricevitore vicino a fonti di interferenza. Posiziona il ricevitore a 1 m di
distanza da terra e lascia almeno 1 m di spazio libero attorno al ricevitore.
TROUBLESHOOTING
Problem
No sound
No sound
No sound
No sound
Distortion level increases
gradually
Bursts of noise or other
audible radio signals are
present
Momentary loss of sound
as transmitter is moved
around the performing
area
SYSTEM SPECIFICATIONS
RF Carrier frequency range ........................................................................... 863.2MHz & 864.8MHzMHz
Max. RF emission ......................................................................................................................... 4.29mW
Operating range ...................................................................................................................... 30m typical
Audio frequency response ........................................................................................... 40-15,000Hz ±3dB
THD ................................................................................................................................................... <0.5%
RECEIVER SPECIFICATIONS
Input power ............................................................................................ 5Vdc via supplied mains adaptor
Signal/noise ratio ............................................................................................................................. >80dB
Border upon channel rejection ........................................................................................................ >80dB
Image & spurious rejection .............................................................................................................. >80dB
Receiving sensitivity ......................................................................................................................... >5dBu
MICROPHONE SPECIFICATIONS
Power requirements ....................................................................................................2 x 1.5AA batteries
Modulation type .................................................................................................................................. F3E
RF output...................................................................................................................................... >10dBm
Max. deviation ............................................................................................................................... ±25kHz
I prodotti elettrici non devono essere gettati nei rifiuti domestici. Per favore portali in un centro di riciclaggio.
Chiedete alle autorità locali o al vostro rivenditore come procedere.
©Copyright Lotronic 2019
Indicator status
Red transmitter indicator doesn't
flash
The red POWER indicator on the
receiver is OFF
The signal indicators A/B on the
receiver are glowing
The signal indicators A/B on the
receiver are off. The POWER
indicators on the transmitter and
receiver are glowing
The signal indicators A/B on the
receiver and LOW BATTERY
indicator on the transmitter are
glowing
Signal indicators A/B are on
Signal indicators A/B on the
receiver are off when the sound
is lost
PARTY--200UHF
Solution
Slide the POWER ON/OFF switch on the transmitter
to ON. Make sure that the batteries are properly
inserted with the correct polarity (+/-). If the
batteries are correctly inserted, replace them by new
ones.
Check if the mains adaptor is plugged correctly into
the mains outlet and the DC socket. Make sure that
the mains outlet supplies the proper voltage
Increase the volume on the receiver. Check the
output connections from the receiver to the external
equipment
Make sure that the frequencies of the receiver and
the transmitter match.
Move the transmitter closer to the receiver
Replace transmitter battery
Identify potential sources of interference (other RF
sources) and turn off, remove or use a wireless
system operating on a different frequency
Reposition receiver and perform walk-through test
again. If audio dropouts persist, mark "dead" spots
and avid them during performance
29